Codes erreur Buffalo Nas

Au démarrage de votre Nas Buffalo, la petite lampe bleue clignote, le temps du chargement du système jusqu’à ce qu’elle arrête de clignoter pour signifier que le Nas est disponible.

Cependant, en cas de dysfonctionnement ou d’état particulier de votre système, une petite lampe orange d’informations clignote pour vous signifier l’état de votre système.

Elle clignote obligatoirement avec n clignotement(s) long, et n clignotement(s) courts pour vous signifier l’erreur.

Ci-dessous un tableau des codes erreur :

Long CourtDescriptions
1 0 The internal temperature for the LinkStation may exceed the allowable value. Do not place objects in the area around the LinkStation, or install at a cooler location.
1 1 The invalid sectors of the hard drive may reach a dangerous level. Replace the hard drive.
1 2 The RAID array is being degraded mode.
1 3 The RAID array is being formatted.
1 4 The RAID array is being checked.
1 5 The error status of the RAID array is being investigated.
*Data transfers will be slower than usual until this is complete.
1 6 The RAID array is being created.
1 7 The RAID array is being resynchronized.
*Data transfers will be slower than usual until this is complete .
1 8 The RAID array is being reconfigured.
*Data transfers will be slower than usual until this is complete.
1 9 The RAID array is being erased by filling 0 in the array.
2 0 Formatting the hard drive.
2 1 Checking the hard drive.
2 2 Erasing the data of the hard drive.
2 5 Updating the firmware.
*Do not turn LinkStation OFF during the update.
2 6 Initializing the settings in the Web Admin interface.
2 7 Checking a USB hard disk.
2 8 Formatting a USB hard disk.
3 2 Appears when RAID rebuilding or formatting on the web Admin interface is necessary after replacing the hard drive. Rebuild or format the RAID array in the LinkStation’s Web Admin interface.
4 6 Data is being transferred or RAID is being migrated.
Do not turn off LinkStation.
4 7 Data is being transferred or RAID is being migrated.
Do not turn off LinkStation.
5 2 A new firmware version has been released.
Update the firmware.